October 13, 2026
There’s a particular kind of disappointment that comes with a stove that won’t deliver. You’ve lit it, you’ve fed it, it’s been going the best part of an hour, and the room is somehow still cold while the glass quietly goes brown at the corners. We get this email every October, usually with a photo of a sad, smoky fire attached. The good news is that nine times out of ten it isn’t the stove, and it isn’t anything that needs an engineer. It’s one of a handful of things, all of which you can fix tonight. Here they are in the order we check them, starting with the one that’s nearly always the answer.
Most cold stoves come down to this. A freshly felled log is around half water by weight, and every bit of that water has to boil off before the wood gives you any heat. A log at 50% moisture gives little more than half the usable heat of the same log at 20%, and the heat you lose goes straight up the chimney as steam, taking tar with it. The catch is that wet logs rarely look wet. Wood that’s been “seasoned” in a garden for a year is usually dry on the outside and still 25–35% in the middle, because air drying only works if the logs are split small, stacked off the ground and left open to the wind for eighteen months or more. Most garden stacks don’t manage that.
The tell-tale signs are a log that hisses or bubbles at the cut end, heavy smoke, a lazy orange flame that won’t take hold, and a stove that only keeps going with the door cracked open. Kiln dried logs are under 20% all the way through, which is the Ready to Burn legal limit; ours are under 18%. The difference is immediate: the log catches within a minute, the flame is bright and busy, and the heat comes into the room instead of going up the flue. If you want to know for certain, a £20 moisture meter settles it. Split a log and press the pins into the fresh inside face, not the bark; the outside can read 15% while the middle reads 35%, and it’s the middle that has to burn.
A wood burner only works properly when it’s hot. The firebox needs to reach the temperature where the gases coming off the wood burn as well as the wood itself; below that, they go up the chimney unburnt as smoke, which is wasted heat and future soot. So light it with every air control fully open and leave them alone for the first ten to fifteen minutes, until the logs are well caught, the flames reach the top of the firebox and the glass is warm to the back of your hand. Only then start closing down: primary (bottom) air most of the way shut, run on the secondary (top) air, and adjust in small steps with a few minutes between each.
The mistake is closing everything early to make the logs last. What you get is a cool, smoky, slumbering fire that gives less heat, blackens the glass and coats the flue. Logs last longer in a hot, well-controlled stove than in a choked one, because they burn completely.
A fire needs air moving through it, so a firebox packed to the top on lighting just smoulders. Start with:
If you’ve never tried the top-down method, it’s worth it: logs on the base, kindling criss-crossed on top, firelighter on top of that. The fire burns downwards, the flue warms quickly, there’s far less smoke and the glass stays cleaner. It feels wrong the first time and then you never go back.
Species matters more than people think, and it isn’t that one is good and the rest are bad; they do different jobs. Birch lights in seconds and throws a bright, lively flame, but burns faster, so if you’re feeding birch all evening you’re up and down every twenty minutes. Oak is the densest common firewood: slower to catch, then a steady, high heat for hours from one or two logs an hour. Ash sits between the two, which is why it’s the traditional all-rounder. The way to use them is together: light with birch, and once the stove is hot and the vents are down, feed it oak. We’ve written up the full comparison in which hardwood burns best in your stove.
A rough rule for stove size is the room’s volume in cubic metres divided by fourteen, which gives the kilowatts you need; a normal living room wants 4–5kW. That stove won’t heat an open-plan kitchen-diner with a staircase in it, however well it’s burning, so shut the doors and give it a room it can win. If the stove smokes back when you open the door, or the fire is lazy whatever you do with the vents, something is working against the draught: a cold chimney on the first fire of the day, an extractor fan running in the same room, a very airtight house with no air vent, or a flue that hasn’t been swept in a couple of years. Warm the flue first with kindling on its own for five minutes, turn the fan off, and if it’s still lazy, book the sweep.
Dry logs under 20%, air fully open until the stove is hot, two or three logs at a time, birch to light it and oak to keep it in. Do those four things and most “my stove won’t get hot” problems disappear on the first evening. If you want to be certain the wood isn’t the problem, every log we sell is kiln dried to under 18% and Ready to Burn certified, with free next working day delivery. Start with a bag of oak for the long burn, or the Mega Bundle if you want birch, oak and kindling in one go.
Why is my stove glass going black?
Black glass is a symptom, not a cause: the fire has been burning too cool, from wet logs, air shut down too far, or both. Fix those and the airwash burns it clear on the next hot fire. A damp sheet of newspaper dipped in the cold ash takes thick deposits off in a minute.
Can I leave the stove in overnight?
Best not to. Loading it up and shutting it right down gives almost no heat, coats the flue in tar and is the biggest cause of chimney fires. Let it burn out and relight in the morning; with dry logs you’re back up to temperature in fifteen minutes.
How do I know if my logs are dry enough?
Split one and test the inside face with a moisture meter; under 20% is Ready to Burn, under 18% is where ours sit. Without a meter, dry logs are light for their size, have cracks radiating from the centre, and knock together with a sharp click rather than a dull thud.
Does kiln dried wood really make that much difference?
Yes. It’s the single biggest change most people can make to a stove that won’t get hot, and it’s the one you can make tonight.